Watlow Series 142 Retrofit Manual do Utilizador Página 3
- Página / 54
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Integral – the set point in integral (on board) to the controller.
JIS – Joint Industrial Standards, a set of technical, scientific and dimensional standards developed in Japan. RTD sensors
with the JIS curve change resistance at a rate of 0.00396 ohms/ohms/C.
Line Voltage – the voltage required powering the electronics of the controller.
Low Limit - device will deactivate output on a temperature drop below set point.
On/Off – a method of control that turns the output full on until set point is reached and then off until the process error
exceeds the hysteresis.
Open Brd – the form factor of this controller is an open circuit board mounted on four standoffs.
Manual Reset – the limit must be reset on a power cycle and requires manual reset on limit trip.
Multi RSP – multiple remote set potentiometers were supported. Each allowed the set point to be selected and adjusted.
Relay – refers to an electromechanical relay.
Remote – set point is adjusted using a remote potentiometer.
Panel – the form factor of this controller is mounted through a hole cut in the panel.
PI – Proportional and Integral, a control mode with two functions: proportional action dampens the systems response,
and integral corrects for droop.
PID – Proportional, Integral, and Derivative, a control mode with three functions: proportional action dampens the
systems response, integral corrects for droop, and derivative prevents overshoot and undershoot.
Potted – the circuit board and electronics are encased in epoxy.
Proc – Process input may accept 0-5, 1-5, 0-10 volts or 0-20 and 4-20 mA.
Profiling – Controller will perform a sequence of programmed steps.
Programmable – The feature is changeable in the field through jumpers and/or parameter selection.
RTD – Resistance Temperature Detector, a sensor that is 100 ohms at 0 degrees C and made of platinum material.
SSR – Solid State Relay, these devices will switch AC voltage only and require a load to latch on.
Sw DC – Switched DC, a time proportioning DC output used to drive DC input solid state relays.
t/c – Thermocouple sensor device made by joining two dissimilar metals whose standards is identified by a letter.
Temp Range – the range over which the controller could have the set point adjustment.
Thermistor – a sensor that changes resistance as the temperature changes. Similar but not the same as an RTD.
Universal – Input can be a thermocouple, 100 ohm DIN RTD or process (volts or milliamperes)
VAC – Volts Alternating Current
VAC/DC- Volts Alternating Current or Direct Current
VDC – Volts Direct Current
- Using This Retrofit Guide 1
- Series 142 10
- Installation 48
- External 49
- System Wiring Example 50
- Your Feedback 51
- Warranty 51
- Technical Assistance 51
- Specifications 51
- Ordering Information 52
- Glossary 53
- Declaration of Conformity 54
Manuais e produtos relacionados com Sensores Watlow Series 142 Retrofit
Sensores Watlow Series 146 Manual do Utilizador
(6 páginas)
(6 páginas)
Sensores Watlow Series 147 Manual do Utilizador
(6 páginas)
(6 páginas)
Sensores Watlow PPC-2000 Manual do Utilizador
(320 páginas)
(320 páginas)
Sensores Watlow Series 146 Retrofit Manual do Utilizador
(118 páginas)
(118 páginas)
Sensores Watlow Series 1500 Manual do Utilizador
(90 páginas)
(90 páginas)
Sensores Watlow Series 321 Manual do Utilizador
(6 páginas)
(6 páginas)
Sensores Watlow Series 365 Manual do Utilizador
(16 páginas)
(16 páginas)
Sensores Watlow Series 92 Manual do Utilizador
(13 páginas)
(13 páginas)
Sensores Watlow Series 93 Manual do Utilizador
(52 páginas)
(52 páginas)
Sensores Watlow Series 93 Manual do Utilizador
(52 páginas)
(52 páginas)
Sensores Watlow Series 922 Manual do Utilizador
(92 páginas)
(92 páginas)
Sensores Watlow Series 93 Manual do Utilizador
(52 páginas)
(52 páginas)
Sensores Watlow Series 93 Manual do Utilizador
(52 páginas)
(52 páginas)
Sensores Watlow Series 93 Manual do Utilizador
(56 páginas)
(56 páginas)
Sensores Watlow Series 922 Retrofit Manual do Utilizador
(127 páginas)
(127 páginas)
Sensores Watlow Series 935A Manual do Utilizador
(60 páginas)
(60 páginas)
Diodes MMBD4448 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Hardware Diodes MMBD4448.
Wir stellen 1 PDF-Handbücher Diodes MMBD4448 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentários a estes Manuais