Watlow Relay Interface Board Manual do Utilizador descarregar pdf (Página 8)

Relay Interface Board Installation Guide

Installation

These instructions assume the controller has previously been installed.

Tools Needed

Four, #6 screws

Screwdriver

Mounting

1. Choose a mounting location large enough to accommodate the RIB, the I/O

board or boards, the ribbon cable or cables and wires that connect them.

2. Place the RIB in a suitable location to be mounted and use a pencil to trace

around the plastic standoffs or use the dimension diagram in Figure 1 to posi-

tion the mounting holes.

3. Drill and tap #6-32 holes in the marked locations.

4. Place the Relay Interface Board in the mounting location and insert the #6

screws in the plastic standoffs.

5. Tighten the screws.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Sem comentários

Watlow Relay Interface Board Manual do Utilizador Página 8