Watlow Silver Series OIT Manual do Utilizador descarregar pdf (Página 12)

12 Watlow Silver Series OIT Installation Guide

0600-0069-0000 Rev D

Maintenance

Figure 5: DIP switch connections

SW1

SW2

SW3

SW4

Mode

OFF

Touch Screen Calibration mode

OFF

Reserved

OFF

Force into Boot Loader mode

OFF

Reserved

OFF

Normal operation

- Touch Screen Calibration mode: This mode allows you to

recalibrate the touch screen. You also have the option of

restoring the system passwords to defaults (Caution: all project

data in the OIT will be erased if passwords are reset).

- Boot Loader mode: This mode forces the OIT to not execute

the project. This mode is used when replacing or reinstalling the

operating system. Contact Watlow for more information.

- Normal Operation: All DIP switches must be in the OFF

position for normal operation.

Fusing Requirements

If the display does not come on within two seconds of power up, remove

power. An internal fuse will prevent damage if the polarity of the DC

power is incorrect. Check wiring to insure proper connections and try to

power up again.

1 2 ... 7 8 9 10 11 12 13 14

Sem comentários

Watlow Silver Series OIT Manual do Utilizador Página 12