Watlow EZwarePlus Programming Manual do Utilizador Página 246

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 245
238 EZwarePlus Programming Manual
Configuring the Modbus Gateway
1. Configure the PLC to which Modbus registers will be mapped. Refer to the System Parameter Settings
section at the end of Chapter 6.
2. On the Model tab of the System Parameter dialog, change the HMI Station Number to the Modbus Unit
Number desired for the HMI.
3. Change the Port Number to the port used by the ModbusTCP Master. Typically, port 502 is used.
Add the Modbus RTU/TCP Slave protocol to the project, and set the PLC I/F to Ethernet. Refer to the System
Parameter Settings section at the end of Chapter 6.
1. Check the Enable checkbox in the MODBUS TCP/IP Gateway section
1010-1015, Rev. 03
Vista de página 245
1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 263 264

Comentários a estes Manuais

Sem comentários